waferdicing:start - Tate Lab Wiki

Tate Lab Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Si wafer dicing ======
Email excahnge between Paul Newhouse to Chris Reidy April 2011, describing wafer dicing.  We will clean this up in time.
//
To Paul from Chris//: I'm trying to figure
out where you got some silicon substrates that I found.  They are mounted in
a circular metal frame, stuck on dicing tape.  The wafer was cleaved into
many 10*15mm dies, and they appear to have a thermal oxide layer on them
that gives a purple color to them.

//From Paul to Chris//: Yes, what you have described are indeed Si/SiO2 wafers diced nicely into
10*15 mm substrates.  These wafers were acquired from Hewlett Packard's site
in town, since, at the time, Janet's group and Doug Keszler's group had a
collaboration with the people out there and we could get substrates from
them.  You see, HP has (or had) a very nice dicing saw, allowing them to
mount the wafers on plastic, and then dice them into those small 10 by
15's.  The dicing saws are expensive and the cutting takes a skilled
operator.  In general, I usually got my diced wafers from Steven Meyers, Kai
Jiang, or Jason Stowers (now all are employees of Inpria--ask Doug or Janet
if you're not sure, but they still work on campus a lot).  They usually had
plenty of these diced wafers, and would let me have as many as I needed,
sometimes in a 1" by 1" size, too.  We needed this particular size (10 by
15) to work with the device testing done by Wager's group in EE.  They also
fit a nice die that Ted Hinke (former machinist) made for me a few years ago (look for it
around the labs, I can send you an image if you can't find it).  This die
holds the 10*15 wafer and has mounting pegs that locate channel and contact
masks.

To summarize, first talk with Steve to see what he says.  They might have
some old ones laying around you can have.  Also, I would inquire around
campus--some faculty might have acquired a dicing saw recently, which would
allow you to dice up wafters on campus (also ask Chris Tasker, a great
equipment resource person--Janet knows who he is).  All you would need to do
is acquire some thermal oxide wafers, of which there should be tons,
especially around the cleanroom in EE.  Another option is UO.  I imagine
that between, OSU/UO/ONAMI someone has a dicing saw.  Getting HP to do
anything was always a bit of a pain, so I'd try all other options first.
And by all means, use the ones you find around our labs.

Trace: • reports • substrate • leakdetector • theses • welcome • ellipsometry • lightmicroscope • navigation • computers • opticalmicroscope

Navigation

Search

Toolbox

QR Code