Chemistry 660 Homepage--Fall 2003 Professor James Ingle

Corrections for the first printing of Spectrochemical Analysis

preface, p xiv, 2nd column, 2nd line from bottom

replace made with make

1. p 9, 1st column, last paragraph, line 2

replace throughout with throughput

2. p 17, fig. 2-3 caption, line 12

replace the third M by S

3. p 17, fig. 2-2b

replace Area r² by Area = r²

4. p 18, line 1

replace M₁ by (M₁)

5. p 24, 2nd column, 6th line

replace background with blank

6. p 31, 2nd column, 13th line from bottom

change 333 to 393

7. p 37, fig. 3-5c

change each 2 to 2t

8. p 38, 1st column, line 11

change each 2 to 2t

9. p 40, 1st column, line 8

delete the first "waves"

10. p 45, 1st column, in mechanical chopper section, 2nd paragraph, line 4

replace an with and

11. p 51, 1st column, line 4

add 'e' at end of plan

12. p 55, fig. 3-27 caption

line 5, replace makes a make

line 6, replace ray by rays

13. p 61, 1st column, 2nd line from bottom, replace . by =

14. p 63, 1st column, 4 lines from bottom

eliminate the "dot" over the c in monochromatic

15. p 67, column 1, line 16, change 3-48 to 3-52

16. p 76, 2nd column, 2nd paragraph, line 8

replace given with give

17. p 84, problem 3-1, line 6

add after last sentence, "Assume 0_air(579) = 1.003".

18. p 84, problem 3-2, line 1, insert convex between F/2 and lens

19. p 84, problem 3-3f, line 3

replace special by spectral

20. p 86, problem 3-30, 3rd line

replace nm by cm

21. p 89, first column,

line 11, replace radiance by emittance

line 12, insert "and multiplied by B" after equation 4-3

equation 4-5 should read

line 14, the number and units should be 5.6697 x 10^-12 W cm^-2 K^-4

22. p 98, 2nd column, line 5

add a minus sign in front of the second M and replace the third M by F

23. p 104, figure 4-20 caption, 4th line from bottom

replace undirectional with unidirectional

24. p 106, line 2 after equation 4-21

replace than with that

25. p. 107, 1st column, in subtitle above equation 4-22

replace Responsitivity with Responsivity

1st column, last line, replace in by is

26. p 109, 1st column, line 24

replace pyroelecric with pyroelectric

27. p 114, 1st column, 4th line from bottom

replace showns with shows

28. p 116, 2nd column, line 35

replace intesifier by intensifier

29. p 118, 2nd column, 2nd paragraph, line 14

replace particular with particularly

30. p 125, fig 4-37

replace Multiplexer by Multiplier

31. p 137, 1st column, 5th line from bottom

replace a with an

32. p 141, 1st column, 3rd complete paragraph

in line 3, change 1.0 s to 0.5 s

in line 4, change 0.5 s to 1.0 s

33. p 144, 2nd column, 4th line from bottom

after flicker factor, add P so it reads 'flicker factor P'

34. p 146, 1st column, 2nd paragraph from the bottom, line 1

replace proportion with proportional

35. p 146, 1st column

 20th line from bottom, the line should read, "(J K^-1)(K)(S) = V² Hz^-1. Note ^...

16th line from bottom, delete one "be"

36. p. 148, 2nd column, 3rd line below equation 5-35

eliminate one "the"  

37. p 151, Table 5-5

2nd row, replace 0.00033 by 0.00031

4th row, replace 0.000033 by 0.000031

38. p 161, problem 5-3, lines 4 and 5 should read

"ground signal noise and excess dark current noise are negligible and that the amplifier-readout noise is equal to the Johnson noise."

39. p 166, fig. 6-1 caption,

line 6, replace E_k by E_bk

line 9, replace E_bk by E_k

40. p. 169, Table 6-2, last column, 2nd row

the T bar in parenthesis should be squared as in the two expressions below, i.e.,  (s_st/T)² 

41. p 178, 2nd column

9th line from bottom, replace S_s by S_x

4th line from bottom, delete the "and"

42. p 179, equation 6-19

replace c_x' by c_s'

43. p 187, problem 6-9, 2nd line

insert "shot" between luminescence and noise

44. p 193, fig. 7-4b

switch the positions of the labels sample capillary and nebulizing gas

45. p 203, 1st column, line 19

replace the first -½ by +½

46. p 212, 1st column, unnumbered equation at top

in the exponent, move /kT up one-half line spacing

47. p 219, equation 7-50

in the denominator, insert "t(8)" between I and d8

48. p 291, 1st column, 1st complete paragraph, 3 lines from bottom

add a in front of way so it reads 'a way that'

49. p 343, 1st column, eq. 12-46

replace n_Q by [Q] in the last term of the denominator

2nd column, line 13, replace K_q by K¹

50. p 347, 1st column, under Environmental Effects section

line 1, change a to as

line 3, change affect to effect

51. p 369, 2nd column, line 9

change in to is

52. p 372, column 1, line 13

switch positions of away and toward

53. p 391, figure 13-19 caption, line 6

delete the at end of line so it reads "in which only the"

54. p 396, fig. 13-22 caption, line 11

replace 67 by 62

55. p 401, problem 13-15, line 2

change X_s to >_s

fixed to this point

33. p 432, 1st column, line 14

replace mircroreflectance by microreflectance

34. p 445, fig. 15-15b

the axes labels should be switched

35. p 483, 2nd column, line 22

replace mg by µg

36. p 496, fig. 16-2b

37. p 542, 2nd column, line 1

add F. M. Curran as the first author

22. p 547, 1st column, line 18

eliminate the first a so it read "or with a"

more to come for later pages